Supplies
Needed
Actual Purchase at Home Depot
(1) - ½” x 5’ Copper Pipe        $8.74
(4) - ½” CPVC end caps          $1.00
(2) - 1”x1” x 36” Hardwood    $5.38
(1) – 2’ x 4’ Hardboard            $3.95
Total with taxes                       20.88

Items we had on hand:
     (4) #16 Forming Nails – has two heads
     (4) Stacker Pegs – minimum 2 x 2 inches, cut at a minimum 5” height
     (16) Paneling Nails
     (4) #6 Screw -1½ inches long
     (1) sheet Non-slip material (i.e., rubber, sand paper, velcro)

Substitutions:
Instead of copper pipe use a wooden dowel. PVC at ½ inch was flimsy,
therefore we opted for the copper pipe.
Pictures of Items Used

(1) - ½ inch x 5 foot Copper pipe
This will slide through the Pegs.

(4) End Caps
These fit on the ends of the Pipe.

(2) – 1x1 inch by 36 inch walnut
This is to build the Frame.





(1) – 2 x 4 Hardboard 3/16 inch thick
This will be the floor of the stackers.
Pegs - We used a tree limb, cut from a walnut tree.
             (I knew you’d get a chuckle!)

(4) – 2” x 2” x 5” pegs
This is what the puppy will stand on.

Substitution:
(4) – 2” x 2” x 5” square cut lumber or PVC pipe
with end caps top/bottom.
© BILL & DARICE RAGAN
2008 ALL RIGHTS
RESERVED
POOR MAN'S STACKERS
POOR MAN’S STACKERS
NEXT
NEXT