- Now you’re ready to drill holes in the pegs.
- Clamp the peg to table.
- We used a 5/8” wood drill bit to match the ½ inch diameter of the copper pipe.
- Slide the pipe through the hole.
- Glue non-slip material on top of peg for good footing.
- The fuzzy side of adhesive-backed Velcro used here.
- After both pegs are on the pipe, place CPVC caps on pipe ends.
POOR MAN'S STACKERS
| © BILL & DARICE RAGAN 2008 ALL RIGHTS RESERVED |
| THE PEGS |
POOR MAN’S STACKERS
